1SN-5G, SC-7G and SC-10GGAS FIRED CONVECTION STEAMERINSTALLATION – OPERATION – MAINTENANCEBLODGETT OVEN COMPANYwww.blodgett.com44 Lakeside Avenue, Bur
10COLD WATER CONDENSERThe steamer is equipped with a cold water condenser in the rear of the cooking chamberwhich helps to condense the steam prior to
113.0 PERFORMANCE CHECKOnce the steamer is installed and all mechanical connections have been made,thoroughly test the steamer before operation.1. Ch
124.0 OPERATION INSTRUCTIONSWARNING: The steamer and its parts are hot. Use care when operating, cleaning orservicing the steamer. The cooking com
13WARNING: In the event a gas odour is detected, shut down equipment atthe main shut off valve and contact the local gas company or gas supplierfor s
14STEAM COOKINGYour steamer efficiently cooks vegetables or other foods for immediate serving. Steamcooking should be carefully time controlled. Kee
155.0 PERIODIC MAINTENANCENOTICE: As a safety precaution, disconnect the power supply during cleaningor servicing.CLEANINGAt the end of each day, or
16CLEANINGWeekly, or more often if necessary:1. Clean exterior with a damp cloth and polish with a soft dry cloth.2. Use a non-abrasive cleaner to rem
17MAINTENANCESTAINLESS STEELTo remove normal dirt, grease or product residue from stainless steel, use ordinary soapand water (with or without deterge
186.0 DELIMING PROCEDURE (For units equipped with this feature)WARNING: Read and follow instructions on the CLR bottle. Use plastic orrubber gloves
197.0 TROUBLESHOOTINGADJUSTMENTSAll units are adjusted at the factory. In case of operation problems at initial installation,check type of gas and m
2IMPORTANT NOTES FOR INSTALLATION AND OPERATIONThis is the safety alert symbol. It is used to alert you to potentialpersonal injury hazards. Obey al
20Water flows into cooking compartment:1. Shortage of circuit at operating probe and body.2. Scale build-up on operating probe inside generator.3. Wat
3TABLE OF CONTENTS DESCRIPTION PAGE1.0 Service Connections ...
41.0 SERVICE CONNECTIONS – SN-5GMIN.4 [102]16 [406]1 [25]1.75 [44] 4 [102]40.38 [1026]5 [127]12 [305]SAFETY RELIEFVALVE23.19 [589]GCD16.75 [425]32 [8
5SERVICE CONNECTIONS – SC-7G and SC-10G1 [25]12 [305]6 [152]1 [25]20 [508]10 [254]21.63 [549]76.25 [1937] SC-7G76.13 [1934] SC-10G23.75 [603]12 [305]S
62.0 INSTALLATIONGENERALInstallation must conform with local codes, or in the absence of local codes, with theNational Fuel Gas Code, ANSI Z223.1/NFP
72.2 WALL EXHAUST FAN:The exhaust fan should be installed at least two feet above the vent opening at thetop of the unit.2.3 CLEARANCES:Adequate cle
8GAS CONNECTION:1. The Serial and Rating Plate on the unit indicates the type of gas your unit isequipped to burn. DO NOT connect to any other gas ty
9ELECTRICAL CONNECTIONWARNING: Do not connect the appliance to the electrical supply until after the gasconnection has been made.120 VAC-60 Hz-Single
Comentários a estes Manuais